Yukon Oil Furnace Owner's Manual download pdf (Page 4)

IMPORTANT

Please read all instructions carefully before

attempting installation of this unit. Installation

should only be done by a qualified installer.

UNPACKING AND INSPECTION

Inspect the unit for visible damage. The furnace is shipped in three cartons.

Contents of items shipped is as follows:

1. Carton One: The basic furnace comes in the crate. Inside the

filter door, below the flue outlet, is the pre-assembled, circu-

lating fan, motor, belt, drives and drip shield. The air filter lies

in a frame above the fan. Inside the furnace wood-firing door

are three wood grates, secondary air shut-off assembly, smoke

pipe draw collar, primary air draft tube and door handle weld-

ment. Remove these items and set aside for later installation.

2. Carton Two: This accessory package contains the secondary

air intake cover, thermostats, barometric damper, fan and limit

control, damper control unit, transformer, wiring harness, fume

sensor (gas only) and owner’s manual.

3. Carton Three: The oil or gas burner is in this carton pre-as-

sembled and ready for installation.

RULES FOR SAFE INSTALLATION AND OPERATION

1. Read these rules and the instructions carefully. Failure to fol-

low these rules and instructions could cause a malfunction of

the furnace. This could result in death, serious bodily injury

and/or property damage.

2. Check your local codes. The installation must comply with

them.

3. Use only the type of fuel approved for this furnace. Over-

firing will result in failure of heat exchanger and cause dan-

gerous operation.

4. Oil storage tanks, piping and valves should be installed and

tested in accordance with NFPA 31.

5. You must have a sufficient supply of combustion air to the

area in which the furnace is located. (page 17)

6. Factory Built Chimneys: Connect this furnace to a chimney

that complies with NFPA 211 3-1.2. Factory built chimneys

for use with wood-burning appliances shall comply with the

HT requirements of UL 103 or CAN/ULC-S629-M87. This

means you must install what is referred to as type HT all fuel

chimney.

Masonry Chimneys: Connect this furnace to a chimney that

complies with NFPA 211 3-1.2. A field constructed chimney of

solid masonry units, bricks, stones, listed masonry chimney

units, or reinforced Portland cement concrete that is lined with

suitable chimney flue liners and built in accordance with the

provisions of Chapter 4 of this standard.

7. Follow a regular service and maintenance schedule for effi-

cient and safe operation.

8. Before servicing, allow furnace to cool. Always shut off elec-

tricity and fuel to furnace when working on it. This will prevent

electrical shocks or burns.

FURNACE SPECIFICATIONS

MODEL LWO-112 (Oil)

Input rating 140,000 BTU

Nozzle 1.0 G.P.H. - 80 H

Burner Wayne Model - MSR

MODEL LWG-112 (Gas)

Input rating 140,000 BTU*/HR

NAT L/P

Orifice 7/32” (.218 dia.) 29 (.136 dia.)

Manifold Pressure 3.5 W.C.P 10.0 W.C.P.

Burner Wayne Model P250-AF-DI-Y

MODEL LWO-112 or LWG-112

Blower Size 10” x 10”

Blower C.F.M. 800 - 1800

Motor Size 1/3 - 1/2 - 3/4 HP

Firebrick Lined 2” THICK

Cast Iron Grates YES

Wood Fire Door 11” x 10”

Air Filter 20” x 25” x 1”

Wood Combustion Chamber Size 24” x 16”

MODEL LWO-168 (Oil)

Input rating 189,000 BTU

Nozzle 1.35 G.P.H - 80 H

Burner Wayne Model - MSR

MODEL LWO-168 (Gas)

Input rating 189,000 BTU*/HR

NAT L/P

Orifice “F” (.257 dia.) “23” (.154 dia.)

Manifold Pressure 3.5 W.C.P 10.0 W.C.P.

Burner Wayne Model P250-AF-DI-Y

MODELS LWO-168, LWG-168

Blower Size 11” x 10”

Blower C.F.M. 1200 - 2000

Motor Size 1/3 - 1/2 - 3/4 HP

Firebrick 2” THICK

Cast Iron Grates YES

Wood Fire Door 13-1/4” x 13-1/4”

Air Filter 20” x 25” x 1”

Wood Combustion Chamber Size 24” x 18”

NOTE

It is recommended that a 2”, noncombusti-

ble, raised pad be used for the furnace. This

will prevent moisture from getting under the

furnace and causing corrosion.

INTRODUCTION

This manual provides installation, operation and maintenance instructions as well as parts ordering information for the combination oil/gas

solid fuel furnace models LWO-112 or LWG-112 and the LWO-168 or LWG-168.

1 2 3 4 5 6 7 8 9 ... 31 32

Comments to this Manuals

No comments

Yukon Oil Furnace Owner's Manual Page 4

Comments to this Manuals

Related products and manuals for Stoves Yukon Oil Furnace